TYLOHELO Elite Mode D'emploi page 36

Activity/Status buttons
These buttons are used to start an activity. The button that is in colour indicates the current status.
In Standby mode the sauna temperature is reduced. When guests enter the sauna, they press the start button or external switch to
quickly heat the sauna to the desired temperature (see picture). You can define the extent to which the temperature is reduced under
Configure. The Standby function can be started manually (by pressing the button) and via the calendar/weekly program. The temperatu-
re is not reduced for steam generators. The water in the tank is kept at a temperature of 95 °C instead (can be modified under Configu-
re). Pressing On or Start (see below) will cause steam production to start immediately.
The Standby function can be switched off under Configure. The button will then not appear on the Home screen.
There are more Activity and Status button screens, particularly when the panel is locked. These will be explained under the Code lock
function.
The device is switched off.
The device is in Standby mode.
Appearance when the device is in Standby mode and the panel is locked using a PIN. If you press
Start, the device will switch to standard operating mode for the time defined under Session Time
External Switch. The button changes its appearance and name (see picture below) to Restart session
time. The operating time restarts whenever Restart session time is pressed.
Example: The device is in Standby mode and Session time external switch is set to 30 minutes. If you
press Start, the button changes to Restart session time and the device switches to standard opera-
ting mode. After 15 minutes, if you press Restart session time again, the device will run in standard
operating mode for a further 30 minutes. If there is time remaining on the Standby session time
when these 30 minutes are up, Standby mode will resume. Otherwise the device will switch off.
The device is operating.
The device is in Drying mode.
Combi heaters, steam generators and Tylarium devices have a Drying mode. Once
you are finished after the steam generator has been operating (Combi and Tyla-
rium), the sauna will be heated to 80 °C for 20 minutes to dry out any remaining
moisture. If you have a steam room with a fan, the fan will start once you are finis-
hed and will operate for 20 minutes (this time can be configured under Configure/
Fan). To switch off Drying mode, press the Stop button.