TYLOHELO Elite Mode D'emploi page 48

Standby
The Standby function is activated and deactivated under Standby. This energy-saving
feature is primarily intended for use in public systems. Enter the number of degrees by
which the defined temperature should be reduced during Standby sessions.
For steam generators enter the desired water temperature. The default is 95 °C. Steam
is quickly produced by pressing Start or external switch.
External switch
External switch is a separate Start/Stop button (Tylö part number 90908047) which
can be purchased as an accessory. In order to use external switches, a door switch must
be connected in the sauna (Tylö part number 90908035). The external switch can be
configured for two functions: Restart session time and On/Off. This means that each
press on the external switch produces an extension according to the session time that
is defined for the external switch, without the machine stopping. The machine stops
operating when the session time defined for the external switch ends or when you
press Off on the Elite. The On/Off function means that the session time is started by
pressing the external switch but stops operating completely if it is pressed again.
The Tylö external switch also features an LED status indicator. A continuous light in-
dicates that the device is on. A slow flashing light indicates that the device is program-
med to start later, and a fast flashing light indicates that an error has occurred (e.g. the
door has been opened when a program was about to start).
Connections
Connections are used to configure any accessories connected to your device. There are
two different kinds of connections. On/Off, which provides continuous control of the
connected product; and Fragrance, which is there to control Tylö's fragrance pumps.
Whichever connection is selected, you must provide a name for it. The fragrance
pump is defined by indicating how long you want fragrance fluid to be pumped in and
the interval between pumping processes.
As soon as a connection is activated, it will appear as a slider under Settings. It can be
started and stopped manually, but can also be started automatically via Favourites. If a
connection is activated via Favourites, you can always switch it off manually via Set-
tings.
Connections that are started during operation are automatically switched off when the session time
ends or if you switch off manually via the Elite panel.
In Standby mode, any Connections must be started manually. But the connection starts automatically
if you press On or external switch.
All connections have a maximum current of 10A and are potential-free. They must be safeguarded via
the distribution board fuse and the cable dimension is determined by said fuse.