TYLOHELO Elite Mode D'emploi page 43

Calendar (continued)
Set up a date and calendar program
Go into the calendar and select the desired date.
Add a program by pressing +.
Start by defining when you want the sauna/steam room to be ready for a session.
The system will calculate when the device needs to start in order to reach the desired
session temperature.
Now choose whether this will be a regular session or Standby mode.
Choose whether to define the temperature, humidity and session time or use a Fa-
vourite setting.
Confirm by pressing . The program is indicated by a circle around the date in the
calendar overview.
The procedure for creating a day-based program is identical.
"Ready" means that the system learns how long it takes to heat the room to the desired
temperature. It does this by calculating the number of degrees by which the temperature
increased per minute the last five times it ran. During the first five times the system runs
a default value is used for temperature increase, but after this the calculated value for
the relevant room is used.
If the Standby function is deactivated under Configure, this option is now shown when
you create a program.
If you select Standby for a steam room, the system will start at the time defined as
"ready". This is because in Standby mode it is not the temperature in the steam room
that is measured, but rather the water temperature in the steam generator.
If the desired "ready" time is not sufficient to heat the room, you will see a notification
about this, and will be asked if you still want to use this time. If you answer Yes, the sys-
tem starts immediately.
Up to 21 calendar programs can be saved.
If a program is in progress and the power cuts out, a weekly program will continue when
the power comes back on (if there is time remaining on the program). A date program
will be deleted.