Program Overview - TYLOHELO Elite Mode D'emploi

Calendar
Date and calendar program
Day-based programs

Program overview

A magnetic contact must be connected to the door (Tylö part no.
90908035) in order to use the calendar functions for the Sauna and
Combi heaters, and also the Tylarium system.
In the calendar function you can create programs for specific dates or
programs that repeat every week. Day programs can be deactivated
using the slider (see below).
When the door switch is connected this adds an additional layer of safety to the system.
The function means that:
1. If you create a program which is due to start later and someone opens the door before
the program starts, it will not start.
2. If the door is opened for more than five minutes during operation, the heater will be
switched off.
Steam generators do not require a door switch, but if one is connected, the safety featu-
re in point 2, above, will also work.
A maximum of 6 programs a day can be created. If the date programs overlap, a warning
will pop up and you will be unable to save the program. The same happens if two day-ba-
sed programs collide.
Activate/deactivate day-based
programs
Day-based programs repeat every week. On the days with active pro-
grams, you will see a number after the day name indicating the num-
ber of programs. If day-based programs are deactivated, the number
appears in brackets. A day program is created in the same way as a
calendar program. Start by choosing a day and then follow the steps
under Date and Calendar Program on the next page.
Date calendar programs and day-based programs may overlap. If this happens, the sys-
tem prioritises programs as follows:
1. Manual start (via panel, external switch or app)
2. Date calendar or delayed start (created in app)
3. Day-based programs
The Programs overview shows all calendar items in the system.