Securing The Control Unit To The Pillar; Connecting The Motors 3 - SOMFY EXAVIA 500 Manuel

2.4 Securing the control unit to the pillar

1
Position the unit mounting bracket against
the pillar/wall.
Check that it is horizontal by placing a spirit
level in the intended location.
Motor M1 activates the gate leaf which
• opens first and closes last,
• opens for pedestrian access.
1
M1 on the le
M1 est à gauche
2 Connect the motors as indicated in the table below:
Connect motor wire...
blue
M1
brown
blue
M2
brown
2
Secure the bracket to the pillar/wall.
OU
to terminal ...
10
11
12
13
EN - Replacing the EXAVIA 500 / WISPA 800 / SGS 201SGS 400 / SGS 501 electronic unit - SOMFY
3
Secure the base of the unit to the pillar/wall:
1 screw to secure the unit to the bracket + 2
screws to secure the unit to the pillar/wall.

CONNECTING THE MOTORS 3

With the gate closed, identify the gate
leaf that opens first.
Motor M1 activates this gate leaf.
M1 on the right
M1 est à droite
7