General Introduction; Technical Data; Replacing The Control Unit; Switching The Installation On - SOMFY EXAVIA 500 Manuel

1

GENERAL INTRODUCTION

These instructions describe the procedure for replacing the control unit for Exavia, Wispa and SGS motors.

1.1 Technical data

Power supply
Motor type
Motor output
Max. power consumed
(with area lighting)
Standby consumption
Maximum frequency of move-
ments per day
Opening time
Automatic obstacle detec-
tion
Operating temperature
Thermal protection
Index protection rating
2

REPLACING THE CONTROL UNIT

2.1 Switching the installation off
Cut off the mains power supply.

2.2 Disconnecting the power supply, motors and additional devices

Open the control unit.
Disconnect all the cables coming into the control unit terminal.
Remove the unit being replaced.
Mark the cables (motor 1, motor 2, accessories, power supply) so it is easier to connect them to the new electronics. N.B.,
we regularly improve our products. The terminals on these new electronics may differ from the electronic terminals being
replaced.

2.3 Installing the sealing strip

Fit sealing strip (3) inside the top of the control unit.
6
EN - Replacing the EXAVIA 500 / WISPA 800 / SGS 201SGS 400 / SGS 501 electronic unit - SOMFY
230 V-50Hz/24 V (with solar power)
24 V
120 W
600 W
3 W (without accessories)
20 cycles per day
10 cycles per day using solar power
20 s minimum to 90°
Compliant with standard EN 12 453
-20°C to +60°C
Yes
IP 44
Built-in radio receiver
Remote controls:
- Radio frequency
- Range in field of use
- Storage quantity
Possible connections:
- Output for flashing light
- Lighting output
- Accessories power supply
output
- Back-up battery input
- Photo-electric cell input
- Dry contact type control input
Yes
433.42 MHz
~ 30 m
16
Flashing, 24 V, 10 W max.
500 W max. 230 V (halogen or
incandescent lights only)
24 Vdc/15 W max.
Yes
Yes
Yes (does not operate if battery
power supply
or solar power supply)