Honda Miimo HRM40 Guide D'installation page 19

Mapping the garden
6.4
Type A: Single Lawn (1 Docking Station)
Press the key to map the garden.
The blades do not rotate when the machine follows the wire during mapping. Whilst mapping your Miimo will follow the
wire around the edge of the lawn area. Mapping is complete when the machine touches the docking station. Confirm this
on the screen when prompted. Then the mower will drive back for a few meters to enter the docking station.
Note: walk alongside Miimo while it is following the edge.
Type B: Multiple lawn areas (1 docking station)
During the mapping, Miimo will not follow the wire leading to the additional area. This area will not be mapped.
The additional area will not be included in the calculated lawn size displayed in the "my lawn" section of the App.
Your Miimo will navigate the additional area in a random mowing pattern. Areas with a docking station are cut in parallel
lines using Map & Mow Intelligent Cutting.
Type C: Separated gardens (2 or 3 docking stations)
After mapping the first garden, carry the mower to the next garden.
Place the mower into the additional docking station. Make sure the mower and the docking station are switched on and
press the key. Mower displays "Map Now" .
After the mapping has been completed, the mower will return to the docking station and will save the map.
Now your Miimo is able to navigate the lawn, cutting the grass in parallel lanes.
If you have a 3 garden with a docking station, repeat the process.
rd
Mapping excluded objects
6.5
During the mapping, excluded objects will not be mapped. Mapping of the objects will happen during the first 3 cutting
sessions. When the Miimo encounters an object that has been excluded, using the perimeter wire, it will follow it around
to establish its shape.
Your Miimo will then drive to the outer perimeter wire and follow it until it has confirmed the location of the object. It may
return to the docking station.
The newly discovered object will be saved automatically in the map.
This process will be repeated with every object.
Set the height of cut for the grass.
6.6
It is recommended to start at a higher setting and then gradually
reduce the level as the the wire disappears under the grass. This
will prevent your Miimo cutting the wire.
Note: the Miimo is designed to cut small pieces of grass (5 mm)
that drop down and fertilise the soil.
GB
19