Honda Miimo HRM40 Guide D'installation page 16

Marking additional lawn area (Type B see section 1)
5.4
Additional lawns can be connected with the same perimeter wire if the
additional lawn is smaller than 40 m
positioned in the main area.
1. Determine the passage where the perimeter wire will run from the main area to the additional area.
2. Run the wire from the main area along the passage to the additional area. Do not fully immerse the pegs in the
lawn, as these will be used when the wire is returning to the main area.
3. Continue around the additional area in an anti-clockwise direction whilst maintaining the recommended distances as
described in section 5.
4. Lay the wire back to the main area through the same passage. The returning wire should be laid under the same
side of the pegs.
Laying the perimeter wire around separated garden
5.5
(Type C see section 1).
Follow the same process as for the 1
16
. The docking station needs to be
2
<1 cm
garden.
st