Samsung NX58K7850S Série Manuel D'utilisation page 47

Problem Possible cause
The surface The control knob is not
burners do not set properly.
light.
The burner caps are not
in place.
The burner base is
misaligned.
A surface The control knob has
burner been left in the LITE
clicks during position.
operation.
The burners do The surface burner
not burn evenly. components and caps
are not assembled
correctly and level.
The surface burners are
dirty.
Very large or The wrong burner orifice
yellow surface is installed.
burner flames.
The surface The oven door lock is
burners light turned on.
but the oven
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Action
Push in the control knob and turn
it to the LITE position.
Clean the electrodes.
Put the burner cap on the burner
head.
Align the burner base.
After the burner lights, turn the
control knob to a desired setting.
If the burner still clicks, contact a
service technician.
See page 42.
Clean surface burner components.
(See page 41.)
Check the burner orifice size.
Contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad for
3 seconds. The oven will beep and
the Lock icon will turn off.
Call a qualified service technician.
Oven
Problem Possible cause
The oven There may be a
control beeps malfunction. See the
and displays "Information codes" chart
an information on page 51.
code.
Very large or The oven burner air
yellow oven adjustment shutters
burner flames. need to be adjusted.
The gas supply is not
properly connected or
turned on.
The oven Oven thermostat needs
temperature is adjustment.
too hot or cold.
An oven burner The oven door lock is
will not shut off. turned on.
The Sabbath function
has been activated.
Action
Press the OFF/CLEAR pad, and
then restart the oven.
If the problem persists, disconnect
all power to the range for at least
30 seconds and then reconnect
the power. If this does not solve
the problem, call for service.
Call for a qualified service
technician.
See the Installation Instructions
that came with your range.
See page 36.
The display will show the Lock
icon. Hold the oven door open
and press the START/SET pad for
3 seconds. The oven will beep and
the Lock icon will turn off.
SAb and the time of day will show
in the display. All other controls
and signals will be deactivated. To
turn off the oven only, press the
OFF/CLEAR pad.
To cancel the Sabbath function and
reactivate the controls and signals,
press and hold the Bake and Touch
to Wake-Up pads simultaneously
for 3 seconds.
English 47