Toggle Voice Prompt In User Mode; Power Up - Tone Mode; Reset To Factory Defaults; Keypad Beeps - Motorola RDX Série Guide D'utilisation

PTT button.
• A short press of the PTT Button re-enables iVOX
Note:
• There is a short delay between the time when you
start talking and when the radio transmits.
• For more information on setting VOX/iVOX
sensitivity, refer to "Setting VOX/IVOX Sensitivity"
on page 34.

TOGGLE VOICE PROMPT IN USER MODE

Short press the SB1 Button while turning ON the radio
to enable/disable the Voice Prompt in User Mode.
(Default is set to ON).

POWER UP - TONE MODE

To enable/disable power up tone mode, press SB1
and SB2 buttons simultaneously for 2-3 seconds while
powering up the radio until you hear the pre-
programmed power up tone. Three different power-up
tones are available.
• Power up tone and channel number
announcement, or
• Battery level and channel number
announcements, or
• Silent (Audible tones disabled)

RESET TO FACTORY DEFAULTS

Reset to Factory Defaults will set back all radio
features to the original factory default settings. To do
so, press PTT, SB2 and SB1 simultaneously while
turning ON the radio until you hear a high tone chirp.

KEYPAD BEEPS

To enable/disable Keypad Beeps, short press the SB2
button while turning ON the radio until you hear 'chirp'
tone.

KEYPAD LOCK/UNLOCK

You can lock the keypad to avoid accidentally
changing your radio settings. To lock the radio
keypad, press and hold the (Menu) button for 4
seconds.
Note: The PTT Button and Programmable Button
A (if Call Tone feature has been assigned)
cannot be locked using this feature.
Keypad Lock
icon
33
English