The Seat P - Mutsy 4Rider Mode D'emploi

The carry cot apron
· To assemble the apron, fasten the press
-studs on the indicated positions.
· To remove the apron, unfasten the press
-studs on the indicated positions.
The seat (6 months-15 kg)
· The seat is suitable for children from
6 months up to 15 kg, who can sit
unaided.
· The seat can be assembled into 2
directions and back rest and foot rest
can be adjusted in various positions.
Assembly on the frame (m)
· Place the seat with the fastening parts
above the universal fixation points of
the frame. Push the seat down until it
firmly clicks. Make sure that the seat
is fixed properly and that the red sur-
faces in the universal fixation points
are fully covered.
! Both ends of the seat support hooks
under the seat should always fall in
front of the support-construction.
Assembly on the frame (the child faces
the parent)
· Place the seat with the fastening parts
above the universal fixation points of
the frame. Push the seat down until it
firmly clicks. Make sure that the seat is
fixed properly and that the red surfaces
in the universal fixation points are fully
covered.
! Under the seat there is a Velcro strip
that is attached to the backside of
the seat with a press button. When
you put the seat in the position that
the child faces the parent, the Velcro
strip should be fastened around the
cross-connection and the support-
construction to avoid movement of
the seat.
Removing the seat
· Push the two release buttons of the
universal fixation points in backward
direction until the seat releases.
The seat can now be taken from the
frame.
! If the seat is facing the parent, the velcro
strip with which the seat is attached to
the frame should be released.
The canopy (m)
· Place the canopy in the openings until
it locks.
· To remove the canopy, press the small
press buttons on the canopy parts and
pull the canopy out of the notches.
The bumper bar
· Fix the bumper bar by placing it in the
front openings in the plastic parts
· Push the button marked "press" and
lift the bumper bar up to remove the
bumper bar.
The dinner tray
· Secure the dinner tray by slotting it
into the front notches of the pushchair
seat's plastic attachments section.
Ensure the front bar is removed first.
· To detach the dinner tray, push the
'press' buttons and remove.
Adjusting the back rest (n)
· In order to adjust the back rest, the
press button on the right side of the
seat should be pressed and at the same
time the back rest should be moved
into the desired position.
· The back rest can be moved forward
without pressing the mentioned but-
ton.
Adjusting the foot rest (n)
· If you wish to adjust the foot rest, move
the plastic knobs under the foot rest
towards you simultaneously and move
the foot rest to the desired position.
Adjusting the seat depth (n)
· In order to adjust the seating depth, it
is best to first undo the velcro at the
back of the pushchair seat and tem-
porarily remove the rubber bands from
around the knobs.
· Then push the knobs inwards and turn
through 180º. Move the back of the seat
forwards to increase the seating depth.
! Do not allow fabric to become jammed
in the adjustment mechanism, this may
block the mechanism.
Placing your child in the seat
! Use a harness as soon as your child can
sit unaided.
English
19