Cleaning A Room; Preparing The Room; Switching On The Robot; Starting The Robot - SEVERIN RB 7028 Mode D'emploi

8 Cleaning a room

8.1 Preparing the room

8.2 Switching on the robot

19

8.3 Starting the robot

62
8 Cleaning a room
– Remove any loose objects which may otherwise be
pushed around by the robot.
– Remove cables, draperies, and everything that could get
entangled in the brushes.
– Remove breakable objects or objects that can tip over
easily.
1. Switch on the robot at the On/Off switch (position "I")
(fig. 19).
2. Wait until the Power LED "
Starting from any point in the room
Requirement: The robot must be switched on. chapter
„Switching on the robot", page 62
On the robot:
1. Press the Power LED "
TIP: The default settings after switching on are: Automatic
mode (" ", " ", "
cleaning duration ("99
(" ").
2. Set the cleaning pattern.
chapter „Setting the cleaning pattern", page 64
3. Set the duration of cleaning and the return to the charg-
ing station after cleaning.
chapter „Setting the cleaning duration", page 65
4. Set the suction power.
chapter „Adjusting the suction power", page 65
5. Wait 3 seconds until the robot begins cleaning.
" lights up green.
" to activate the robot.
" and " " light up), maximum
") and normal suction power