Pioneer SVM-1000 Mode D'emploi page 9

NAMES AND FUNCTIONS OF PARTS
37 BOOTH MONITOR level control dial
This dial is used to adjust the booth monitor output volume.
The volume can be adjusted independently of the master output
level. (Adjustable range: –∞ to 0 dB)
38 Channel fader curve switch (CH FADER CURVE)
This switch allows the user to select from three types of channel
fader curve response. This setting is applied equally to channels
1 to 4.
• At the left setting, the curve operates to produce a rapid rise as
the channel fader approaches its distant position.
• At the right setting, the curve operates to produce an even,
neutral rise throughout the channel fader's movement.
• At the middle setting, an intermediate curve is produced,
midway between the two curves noted above.
39 SD CARD slot
Insert an SD card with JPEG image files.
40 UTILITY button (MASTER MONITOR, SET UP)
Use to switch the master monitor display ON/OFF.
Hold the button depressed to display the utility setup screen.
The indicator lights when the master monitor is displaying. The
indicator flashes when the setup screen is displayed.
41 VIDEO EQ button (ON/OFF, SET UP)
Use to switch the video equalizer ON/OFF. Hold the button
depressed to display the equalizer setup screen.
The indicator lights when ON, and flashes when in the setup
screen.
42 JPEG VIEWER button
Use to set the JPEG viewer mode. The indicator lights when in the
JPEG viewer mode.
43 VIDEO SOLO MODE button
Use to switch the video solo mode ON/OFF. When the video solo
mode is ON, the indicator will flash.
44 Fader AV synchro button (FADER AV SYNC)
Use to select whether the video processed by the video mix mode
is linked to the audio.
The indicator lights when linked.
45 Effect channel selector dial (CH SELECT)
Use to select the channel to which effects are applied. When [MIC]
is selected, effects are applied to both microphone 1 and
microphone 2.
46 VIDEO FX PATTERN/TEXT BANK dial
Use to select video effects, video effect patterns and text banks.
47 Effect parameter 1 dial (TIME/PARAMETER)
Adjusts parameter for selected effect.
• If this dial is rotated while depressing the TAP button, direct
BPM can be set manually.
48 Effect parameter 2 dial (LEVEL/DEPTH)
Adjusts quantitative parameters for selected effect.
49 TAP button
The BPM is calculated from the intervals at which the TAP button
is struck.
50 Effect button/indicator (EFFECT ON/OFF)
Turns selected effect ON/OFF.
When power is turned ON, the button lights (defaults to effect
OFF). When effects are enabled (ON), the button flashes.
51 Cross fader lever (A/B)
Outputs audio and video assigned to [A] and [B] sides in
accordance with setting of the CROSS FADER ASSIGN switch, and
subject to the cross fader curve selected with the CROSS FADER
CURVE switch.
9
En