Atlas Copco D2116 Manuel D'instructions Original page 6

Safety and operating instructions
• Use ear protection equipment in noisy environ-
ments.
• Use high-quality inserted tools or consumables to
minimize exposure to excessive levels of vibra-
tion.
• Minimize exposure to reaction forces.
• When cutting:
A cut-off wheel can get stuck if the wheel is
either bent or if it is not guided properly. Make
sure to use the correct flanges for cut-off wheels
and avoid bending the wheel during cut-off
operation.
• When drilling:
The drill might stall when the drill bit breaks
through. Makes sure you use support handles
if the stall torque is too high. The safety stand-
ard ISO11148 part 3 recommends using some-
thing to absorb the reaction torque above 10
Nm for pistol grip tools and 4 Nm for straight
tools.
• When using direct-driven screw or nutrunners:
Reaction forces depend on tool setting and joint
characteristics. The ability to bear reaction
forces depends on the operator's strength and
posture. Adapt the torque setting to the operat-
or's strength and posture and use a torque arm
or reaction bar if the torque is too high.
• Use dust extraction system or mouth protection
mask in dusty environments.
Country of origin
Please refer to the information on the product label.
Spare parts
Parts without ordering number are not delivered
separately for technical reasons.
The use of other than genuine Atlas Copco replace-
ment parts may result in decreased tool performance
and increased maintenance and may, at the company
option, invalidate all warranties.
Warranty
Contact the Atlas Copco sales representative within
your area to claim a product. Warranty will only be
approved if the product has been installed, operated
and overhauled according to the Operating Instruc-
tions.
Please also see the delivery conditions applied by
the local Atlas Copco company.
ServAid
ServAid is a utility for providing updated product
information concerning:
- Safety instructions
6
EN
© Atlas Copco Industrial Technique AB - 9836 3456 00
- Installation, Operation and Service instructions
- Exploded views
ServAid facilitates the ordering process of spare
parts, service tools and accessories for the product
of your choice. It is continuously updated with in-
formation of new and redesigned products.
You can use ServAid to present content in a spe-
cific language, provided that translations are avail-
able, and to display information about obsolete
products. ServAid offers an advanced search func-
tionality of our entire product range.
ServAid is available on DVD and on the web:
http://servaidweb.atlascopco.com
For further information contact your Atlas Copco
sales representative or e-mail us at:
servaid.support@se.atlascopco.com
Safety Data Sheets MSDS/SDS
The safety data sheets describes chemical products
sold by Atlas Copco.
For more information, consult the website
http://www.atlascopco.com/.
Choose Products - Safety Data Sheets, and follow
the instructions on the page.
Decommissioning
Recycling instruction
When a product has served its purpose it has to be
recycled properly. Dismantle the product and recycle
the components in accordance with local legislation.
Batteries shall be taken care of by your national
battery recovery organization.
Technical data
Noise and vibration emission
Noise (in accordance with ISO15744)
Sound pressure level
Sound power level
Uncertainty
Vibration total value, valid from 2010
(3-axes value in accordance with ISO28927-5)
Vibration value
Uncertainty
Noise and Vibration Declaration State-
ment
These declared values were obtained by laboratory
type testing in accordance with the stated standards
and are suitable for comparison with the declared
D2116
dBA
82
93
3
2
m/s
<2.5
-