Table des Matières
Publicité
Speaker connections to TVs
Caution:
Turn off all other equipment before making any connections.
Tuner receiving for other audio system
Placing the aerial near the speaker AC power lead may cause
noise pick up. Place the aerial away from the speaker for
better reception.
Notes:
To connect to TV, use either LINE IN 1 sockets or AUDIO
LINE IN 2 socket only.
Refer the operation manual of the equipment to be
connected.
Fully insert the plugs to avoid fuzzy pictures or noises.
Connecting to a TV
If the TV/monitor has an audio output, connect it to the LINE IN
1 sockets on the rear of the speaker.
TV
RCA cable (supplied)
Speaker
To audio output sockets
To LINE IN 1
sockets
Connecting to a TV (with Headphone
socket)
If the TV/monitor has headphone socket, connect it to the
AUDIO LINE IN 2 socket on the rear of the speaker.
TV
To HEADPHONE socket
Audio cable
(3.5 mm/stereo socket)
(not supplied)
Speaker
Notes:
If the TV volume is continuously in low level, the speaker will
automatically power off. Increase the TV output volume to
enjoy the sound from the speaker.
If the speaker volume is continuously in very high level, the
speaker will mute and recover after 3 seconds.
HEADPHONE
To AUDIO LINE IN
2 socket
RIGHT
LEFT
LINE IN 2
LINE IN 1
HT-SB200
ENGLISH
E-10
Publicité
Table des Matières
