General Control; Display Brightness Control - Sharp HT-SB200 Mode D'emploi

Masquer les pouces Voir aussi pour HT-SB200:
Table des Matières

Publicité

Caution:
Do not use rechargeable battery (nickel-cadmium battery,
etc.).
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
Batteries (battery pack or batteries installed) shall not be
exposed to excessive heat such as sunshine, fire or the like.
Installing the battery incorrectly may cause the speaker to
malfunction.
Notes concerning use:
Replace the battery if the operating distance is reduced or if
the operation becomes erratic. Purchase "CR 2025", coin
lithium battery.
Periodically clean the transmitter on the remote control and
the sensor on the speaker with a soft cloth.
Exposing the sensor on the speaker to strong light may
interfere with operation. Change the lighting or the direction
of the speaker if this occurs.
Keep the remote control away from moisture, heat, shock,
and vibrations.
Test of the remote control
Point the remote control directly at the remote sensor on the
speaker.
The remote control can be used within the range shown
below:
Press the ON/STAND-BY button. Does the power turn on?
Now, you can enjoy your system.
Remote sensor
STANDARD
SPORT
ON/STAND-BY
VOL.
SOUND BAR SYSTEM HT-SB200
CINEMA / GAME
NEWS
SURROUND FUNCTION
0.2 m - 6 m
(8" - 20')
15° 15°

General control

STANDARD
SPORT
ON/STAND-BY
VOL.
SURROUND FUNCTION
SOUND BAR SYSTEM HT-SB200
To turn the power on
Press the ON/STAND-BY button.
The power indicator turns green. If the power does not turn
on, check whether the power lead is plugged in properly.
To set the speaker to stand-by mode:
Press the ON/STAND-BY button again.
The STAND-BY indicator turns red.

Display brightness control

Press the DIMMER button to adjust the brightness of the
display and sound mode indicator.
Sound mode indicator and display bright
Sound mode indicator and display dim
Sound mode indicator and display off. Pressing any button will
light up the display for 3 seconds only.
Volume auto fade-in
If you turn off and on the speaker with the volume set to 40 or
higher, the volume starts at 20 and fades in to the last set level.
Volume control
Speaker operation:
Press volume up (VOL. +) to increase
the volume and press volume down
(VOL. –) to decrease the volume.
CINEMA / GAME
NEWS
00 01 02 .....
59 60
HT-SB200
ENGLISH
E-12

Publicité

Table des Matières
loading

Table des Matières