Instructions For Use; Control Panel Description - Ariston 200 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Heat pump water heater - OPERATING AND MAINTENANCE INSTRUCTIONS FOR THE USER
Hot and cold water separately
No storage
No
With
circulation
circulation
of hot water
of hot water
C.1
Rif. In Allegato C
≥ 50°C
Temp.
-
≤ 3 l
Ristagno
-
Sedimento
-
a.
Temperature ≥ 55°C the whole day or at least 1h per day ≥60°C.
b.
The volume of water contained in the pipework between the circulation system and the tap which has the greatest distance to the
system.
c.
Remove the sediment from the storange water heater in accordance with the local conditions but at least once a year.
d.
Thermal disinfection for 20 min at a temperature of 60°C, for 10 min at 65°C or for 5 min at 70°C at every draw-off point at least
once a week.
e.
The water in the circulation loop shall be not less than 50°C.
No requirement.
-
This electronic storage water heater is sold with a thermal disinfection cycle function not enabled for default; as a
consequence, if, for any reason, one of the above said "Conditions for Legionella growth" could occur; it's hardly
recommended to enable such function by following the instructions mentioned in this booklet [see par. 7.8].
However, this thermal disinfection cycle is not able to destroy any Legionella bacteria in the storage tank; so, if this
function is then disenabled, Legionella bacteria growth might re-take place again.
Note: when this software carries out the thermal disinfection treatment, the energy consumption of the storage water
heater is expected to increase.
Warning: when this software has been carrying out the thermal disinfection treatment, water temperature can cause
severe burns instantly. Children, disabled and elderly are at highest risk of being scalded. Feel water before
bathing or showering.

7. INSTRUCTIONS FOR USE

7.1 Control panel description

Refer to Fig. 13.
The control panel, constructed in a simple and rational way, comprises two buttons and a central knob.
In the upper section, a DISPLAY shows the set temperature or the detected temperature, besides other specific
indications such as the operation mode signal, fault codes, settings and information of the product's condition.
Types of hot water installation
Storage
No
With
circulation
circulation
of hot water
of hot water
C.2
C.3
C.4
In the
storage
≥ 50°C
e
e
water
heater
a
b
≤ 3 l
b
-
-
Remove
Remove
C
C
A
Buttons
Mixed hot and cold water
No storage upstream of mixing
Storage upstream of mixing
valves
No circulation
With circulation
of hot water
of hot water
circulation
of mixed
C.5
C.6
Thermal
Thermal
storage
disinfection
d
disinfection
d
heater
≤ 3 l
b
-
-
-
Remove
73
No storage upstream of
valves
mixing valves
No
With circulation
No circulation
of mixed water
of mixed water
water
C.7
C.8
C.9
In the
≥ 50°C
e
Thermal
Thermal
water
disinfection
disinfection
d
a
≤ 3 l
b
-
-
Remove
-
C
C
Knob
ON/OFF - MODE
With
circulation of
mixed water
C.10
Thermal
d
disinfection
d
≤ 3 l
b
-

Hide quick links:

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

240240 sys

Table des Matières