Cleaning, Care And Storage - GlobalMIND VenenWalker PRO2 Mode D'emploi

Cleaning, care and storage

PLEASE NOTE!
Before cleaning, always remove the connection tubes from the cuffs and the
■
control unit.
Do not use any caustic or abrasive cleaning agents for cleaning. This might
■
damage the surfaces.
It is imperative to ensure that no moisture enters the tube connectors on the
■
cuffs and the control unit.
Always remove the mains plug from the socket before cleaning the control
■
unit.
Allow all parts to dry completely before they are stored away. Allow to dry in
■
the air only or wipe with a cloth. Never use a hair drier or similar for drying
purposes!
1. Clean the cuffs with a clean, damp cloth and if necessary a mild household
cleaning agent.
2. If the cuffs are used directly against the skin by more than one person, they
should be cleaned using a commonly available disinfectant after use so as
to avoid cross-contamination.
3. The control unit and connection tubes should only be wiped with a clean,
damp cloth if necessary. You can also use a mild household cleaning agent.
4. Allow all parts to dry in the air after cleaning or use a cloth.
5. Store the
using it for a lengthier period of time. Keep the storage bag in a cool, dry
place which is protected from direct sunlight and frost; it must be kept out of
reach of children and animals.
Do not place anything on top of the storage bag so that it doesn't get crushed
and the
After frequent use, the connection tubes may widen at the ends and no
longer fi t tightly. In this case we recommend cutting off the ends.
7. Place all parts in the storage bag.
in the storage bag if you will not be
is not damaged!
45