GlobalMIND VenenWalker PRO2 Mode D'emploi page 41

Tip for putting on the cuffs
If the cuffs are already tight around your legs before they are pumped up
be sure to use cuff extensions. Otherwise the cuffs and zips might be damaged.
Several cuff extensions can be used at the same time in order to achieve the
necessary circumference. For details, read Section B) of this chapter: "Applying
cuff extensions".
If you cannot lean forward enough to close the cuffs, try the following:
• Ask a second person to help. Since the cuffs can be fully opened and un-
folded, a second person can easily position them under your legs and close
the zips.
• Before applying the cuffs, close the zips up to approx. the middle of the cuffs
(or as far as necessary). Then sit down, slip into the cuffs and close the zips
completely.
D) Switching on the control unit to start massaging
The
20 – 30 minutes. You can either switch off the control unit manually or activate
the time function prior to switching on. In the latter case, the control unit switches
off automatically after the set period of time.
We recommend using the timer function. This means you do not have to watch
the time and can relax completely during the treatment.
If you fi nd it diffi cult or impossible to hold
the zip slider we recommend attaching a (key)
ring (see picture).
• If it is still too diffi cult, you can attach a
piece of string to the zip slider and close
the zip by pulling the string.
massage should be terminated after approx.
41