Electromagnetic Compatibility (Emc) - GlobalMIND VenenWalker PRO2 Mode D'emploi

36
NOTICE – risk of damage to material and property
Keep the cuffs and connection tubes away from sharp objects. Do not insert
■
safety pins or other pins or sharp objects into the cuffs.
Only plug the control unit into properly installed sockets where the mains
■
voltage corresponds to the voltage specifi cations on the rating plate of the
control unit. Only use appropriate extension cables which comply with the
technical specifi cations of the control unit.
Unwind the mains cable fully before connecting the control unit.
■
Make sure that the mains cable and connection tubes are not crushed, bent
■
or laid over sharp edges and do not come into contact with hot surfaces.
The control unit must be switched off when inserting the mains plug in the
■
socket or removing it.
Remove the mains plug if a fault occurs during operation or before a thun-
■
derstorm.
When removing the mains plug from the plug socket, always pull on the
■
mains plug and never the mains cable. Do not pull or carry the device by the
mains cable.
Do not use the control unit if it has malfunctioned, fallen or been dropped in
■
water. Have it checked in a specialist workshop before using it again.
Always place the control unit on a dry, even and fi rm surface. Do not place
■
on cushions or other soft surfaces in order to prevent the control unit from
overheating.
Do not place the system on or next to heat sources such as hobs or ovens.
■
Keep the system away from open fi re such as candles or cigarettes.
Do not expose the system to extreme temperatures, persistent moisture, di-
■
rect sunlight or impacts. Please refer to the chapter entitled "Technical spec-
ifi cations" for details.
Never place heavy objects on the system.
■

Electromagnetic Compatibility (EMC)

For details, please refer to the back-up documentation or
https://www.venenwalker.com/downloads/