Emerson LUCERE CF575BQ00 Manuel Du Propriétaire page 9

3. Ceiling Fan Assembly
3.9
IMPORTANT: Remove the Clear Protective Film
from around the LED Upper Light.
Loosen the Two Phillips Head Set Screws in the Motor
Coupler for installation of the Downrod (Figure 9).
Seat the Downrod in the Motor Coupler (Figure 9).
Rotate and align the Downrod holes with the Two Holes
in the Motor Coupler (Figure 9).
3.10
Slide the Clevis Pin through the Motor Coupler Holes.
Install the Hairpin Clip through the Clevis Pin Holes to
secure (Figure 10).
NOTE: The Clevis Pin must go through the holes in
the Motor Coupler. It is critical that the Clevis Pin is
properly installed and secure.
WARNING
!
It is critical that the clevis pin and hairpin clip in the
motor coupler are properly installed and secured.
Failure to verify that the pin is properly installed could
result in the fan falling.
(Continued)
MOTOR
COUPLER
REMOVE
PLASTIC
FILM
Figure 9
DOWNROD
CLEVIS PIN
Figure 10
9
9
DOWNROD
LOOSEN
PHILLIPS HEAD
SET SCREWS (2)
film ,
Rem ove the pro tect ive
onl y.
for safe ty pro tect ion
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF575