Emerson LUCERE CF575BQ00 Manuel Du Propriétaire page 12

3. Ceiling Fan Assembly
3.15
Route the Four Wires through the Hanger Ball
(Figure 15).
Reinstall the Hanger Ball on the Downrod as follows:
Position the Pin through the Two Holes in the Downrod
and align the Hanger Ball so the Pin is captured in the
Groove in the top of the Hanger Ball (Figure 15).
Pull the Hanger Ball up tight against the Pin and
securely tighten the Phillips Set Screw in the Hanger
Ball (Figure 15).
NOTE: A loose Set Screw could create Fan wobble.
3.16
The Fan comes with Blue, White, Black, and Yellow
Wires that are 80-inches long.
Before installing the Fan, measure up approximately
6 to 9-inches above top of Hanger Ball / Downrod
Assembly (Figure 16).
Cut off excess Wires and strip back insulation 1/2-inch
from end of Wires.
(Continued)
HANGER BALL
PIN
DOWNROD
Figure 15
1/2
INCH
Figure 16
12
PHILLIPS
SET SCREW
BLACK WIRE
BLUE WIRE
YELLOW WIRE
6 TO 9
INCHES WHITE WIRE
HANGER
BALL
ETL Model No.: CF575