Tools Needed For Assembly; Electrical Requirements - Emerson LUCERE CF575BQ00 Manuel Du Propriétaire

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for You to
Assemble, Install, Operate and Maintain Your Ceiling Fan

Tools Needed for Assembly

One Phillips Head Screwdriver
One 1/4" Blade Screwdriver
Materials
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be
a 3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your Emerson Ceiling Fan comes supplied with a Fan/
Light Remote Control which consists of a Receiver
mounted inside the Ceiling Cover of the Fan Motor
Housing. This system allows you to regulate your
Ceiling Fan Speed and Light ON/OFF.
Your new Ceiling Fan will require a Grounded Electrical
Supply Line of 120 Volts AC, 60 Hz, 15 Amp Circuit.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable
for Fan Support of 22.7kg. (50 lbs.) or less", and use
screws supplied with outlet box. Most outlet boxes
commonly used for support of light fixtures are
not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
One Stepladder
One Wire Stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
This Emerson Ceiling Fan may be used with the
following Accessories (purchased separately):
SR600 - Handheld Transmitter
SW605 - Wall Transmitter
SR650 - Wall/Handheld Transmitter
!
Before assembling your ceiling fan, refer to section
on proper method of wiring your fan (page 15).
If you feel you do not have enough wiring knowledge
or experience, have your fan installed by a licensed
electrician.
1.2
Remove the Fan Motor Assembly from the protective
plastic bag. Place the Fan Motor Assembly,
Bottom of the Motor facing up, on a steady work table.
The Outlet Box must be securely anchored and capable
of withstanding a load of at least 50 Pounds.
If your Fan is to replace an existing ceiling light fixture,
turn electricity OFF at the Main Fuse Box at this time
and remove the existing light fixture.
!
To avoid fire or shock, follow all wiring instructions
carefully.
A n y e l e c t r i c a l w o r k n o t d e s c r i b e d i n t h e s e
instructions should be done or approved by a licensed
electrician.
Please call Technical Support at 1-800-654-3545
if you have any questions about installation and
operation of this Ceiling Fan.
4
WARNING
WARNING
ETL Model No.: CF575