Emerson LUCERE CF575BQ00 Manuel Du Propriétaire page 8

3. Ceiling Fan Assembly
3.7
Carefully turn the partially assembled Ceiling Fan right
side up for preparation of remaining assembly.
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the 7" Downrod (Figure 7).
Remove the Pin from the Downrod, then remove the
Hanger Ball (Figure 7).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.15.
Note: Do not loosen the screw that attaches the
green ground wire to the hanger ball.
3.8
Separate, untwist and unkink the Four 80" Motor Wires.
Route the Four 80" Motor Wires through the Downrod
(Figure 8).
(Continued)
PIN
PHILLIPS HEAD SET SCREW
(LOOSENED)
Figure 7
Figure 8
8
8
GREEN GROUND WIRE
7" DOWNROD
HANGER BALL
80" FAN MOTOR
WIRES (4)
DOWNROD
ETL Model No.: CF575