Emerson LUCERE CF575BQ00 Manuel Du Propriétaire page 25

7. Wall Control Installation
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
7.8
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Outlet Box.
Screw Wall Control into Wall Box using the supplied
screws. Leave Wall Control in "OFF" mode until fan
installation is completed.
Install the second Wall Control (sold separately) into
the Wall Box containing the "Load" Wire. Connect the
Wall Control Black Wire with the Yellow Label marked
"To Power Supply" to the Traveler Wire from the first
Wall Box. Securely connect Wires with Wire Connector
(supplied) (Figure 38).
Connect the Wall Control Black Wire with the Blue
Label marked "To Fan" to the "Load" Black Wire in the
Wall Box. Securely connect Wires with Wire Connector
(supplied) (Figure 38).
Connect the Wall Control Green Ground Wire to the
Bare Copper Wire or Green Ground Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 38).
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
(Continued)
3-WAY WIRING DIAGRAM:
NOTE: Retrofit 3-way installations are likely to
include two traveler wires between the two wall
boxes. In new construction, only one traveler wire Is
required (See Figure 38).
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
HOT
BLK
3-WAY WIRING DIAGRAM: RETROFIT
HOT BLK
BLK
SW605
FAN/LIGHT
WALL
CONTROL
Figure 38
25
25
EXISTING
WALL CONTROL
TRAVELER WIRES
BLK
BLK
SW605
TRAVELER FAN/LIGHT
WIRES
WALL
CONTROL
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF575
LOAD
LOAD