Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
12. Remove the locking pin.
Note
After fitting a new cutting disc, run the tool at full speed under no load for approximately 1 minute.
5.2.2 Adjusting the guard
DANGER
Risk of injury. Flying fragments or sparks could cause injury.
▶ Adjust the guard so that flying particles or fragments of the material removed and flying sparks are
directed away from the operator and the product.
▶ Hold the guard by the grip provided and rotate it to the desired position.
5.2.3 Fitting the water pump (accessory)
1. Release the three pump cover retaining screws, remove the parts and store the pump cover in a safe
place.
Note
The pump cover must be fitted if the tool is used without the water pump.
2. Hold the water pump in position and turn the cutting disc slightly to bring the splines of water pump and
clutch bell into alignment so that the splines engage.
◁ The position is keyed so it is not possible to position the pump incorrectly.
3. Fit the three retaining screws and tighten them securely (tightening torque: 8 Nm).
4. Connect the pump hose to the hose connector on the saw.
5. Remove the protective cap from the end of the water connection hose.
6. Connect the water pump to the water supply or immerse the end of the suction hose in a container filled
with water.
Note
The maximum permitted water supply pressure is 6 bar.
Note
Fit the protective cap to the end of the water connection hose when the water pump is not
connected to a water supply.
5.2.4 Removing the water pump (accessory)
1. Disconnect the water supply from the water pump.
2. Fit the protective cap to the end of the water connection hose.
3. Disconnect the connector between the pump and the tool.
4. Release the three fastening screws on the pump and then remove the pump.
5. Fit the pump cover on the tool, insert the three retaining screws and tighten the screws securely
(tightening torque: 4 Nm).
5.2.5 Fitting the wheel set (accessory)
1. Slacken the two bottom securing screws on the metal guard.
2. Secure the base plate with the two screws.
3. Secure the wheels and washers with the screws on both sides of the base plate.
6 Operation
6.1 Starting the engine 7,
DANGER
Risk of asphyxiation. Carbon monoxide, unburned hydrocarbons and benzene in the exhaust gas
may cause asphyxiation.
▶ Don't work in closed rooms, trenches or pits and make sure the area is well ventilated.
10
English
Printed: 30.03.2017 | Doc-Nr: PUB / 5341985 / 000 / 00
5
6
8
Publicité
Table des Matières
