Cd Mode - auna MC-30 DAB Mode D'emploi

CD MODE

Note: Please make sure that you remove the cardboard shipping
protector from within the CD compartment before you try to use CD
player.
Check that your Micro System is in CD mode. If you are not already in CD
mode, briefly press and release the Mode button on the front of the Micro
System or on the remote control, until you are in CD mode (check the
display). The display will show 'Reading', followed by 'No disc'. If the CD
compartment is empty.
Play a CD
Note: It is not possible to play DVD or computer CDs. Il peut lire les MP3.
1. Press and release the lid of the CD player on the front right edge, where
'Push to Open' is printed. 'Open' will be displayed.
2. Place an audio CD, label side up, into the CD compartment. Please
ensure that you line up the hole in the centre of the CD, with the central
spindle and press down into place.
3. Close the lid of the CD player, pressing down on the front right edge,
ensuring that it 'clicks' shut. 'Reading' will be displayed and after a short
delay, 'Stop' together with the number of tracks and total number of
minutes and seconds on the CD.
CD controls
You can use the following controls on your Micro System in CD mode.
Play
Press and release the Play/Pause button on the Micro System or on the
remote control. The first track will begin to play and the track number and
the elapsed time of the track will be displayed.
Pause
Press and release the Play/Pause button on the Micro System or on the
remote control. The elapsed time of the track will flash in pause mode.
Press and release the Play/Pause button again to continue to play the track/
CD.
EN
43