La Cornue AlberTine 90 Mode D'emploi page 15

Remember that each cooktop burner has a special
safety device that stops the flow of gas if the flame goes
out. When lighting a cooktop burner the safety device
has to be overridden by holding in the control knob so
that the gas can flow. This allows the flame sensor to
heat up and operate the safety device. Keep holding the
knob pressed in to let the gas through to the burner for
few seconds. The igniter should spark and light the gas.
If, when you let go of the control knob, the burner goes
out, the safety device has not held in. Turn the control to
the off position and wait one minute, then try again this
time holding in the control knob for slightly longer.
Hotplate burners will not light
If only one or all the cooktop burners will not light,
make sure that the parts have been replaced correctly
after wiping or removing for cleaning.
Check that there is not a problem with your gas
supply. You can do this by making sure that other gas
appliances you may have are working.
Do the burners spark when you push in the control
knob? If not check the power is on.
ArtNo.324-0005 Oven light bulb
13
Fig.5-1
Fig.5-2
ArtNo.324-0007 Unscrewing the bulb cover