Balluff BSP-B Série Mode D'emploi page 12

Standard and High-End Pressure Sensors
BSP-B... /-V... /-M... /-W... /-K...
Installation
Installation of connections according to DIN 3852
Make sure that:
– the sealing surface on the relevant part is perfectly
clean and free of residues,
– the O-ring seated in the slot provided is undamaged.
1. Screw the device into the mounting thread with one
hand.
Secure devices to the steel pressure connection using
a spanner flat. Observe the following torques:
Torques Connection
according to
EN 3852
1/4" approx. 5 Nm approx. 20 Nm approx. 30 Nm
1/2" approx. 10 Nm approx. 50 Nm approx. 70 Nm
Display and connection housing rotate 320°
Process connection
Fig. 1: Dimensional drawing
2 English
Connection Connection
according NPT
to EN 837
Fig. 2: Electrical connection and process connection
Fig. 3: Display and connection housing rotates 320°
Adapter for process
connection