Setting Mode - AEG FAVORIT 78002 I Notice D'utilisation

USING THE DETERGENT
A B
30
20
SETTING AND STARTING A
PROGRAMME

Setting mode

The appliance must be in setting mode
to accept some operations.
The appliance is in setting mode when,
after the activation:
• All the programme indicators come
on.
• The display shows two horizontal sta-
tus bars.
If the control panel shows other condi-
tions, press and hold Delay and Start
at the same time until the appliance is
in setting mode.
Starting a programme without
delay start
1.
A
+ -
2.
3.
C
4.
5.
1. Open the water tap.
2. Press the on/off button to activate
3. Close the appliance door.
4. Make sure that the appliance is in
5. Press Program again and again un-
6. If you want, you can set the options.
7. Press Start. The programme starts.
CAUTION!
Use only detergents for dish-
washers.
Press the release button (B) to
open the lid (C).
Put the detergent in the compart-
ment (A) .
If the programme has a prewash
phase, put a small quantity of de-
tergent on the inner part of the ap-
pliance door.
If you use detergent tablets, put
the tablet in the compartment (A).
Close the lid. Make sure that the
release button locks into position.
Do not use more than the cor-
rect quantity of detergent. Refer
to the instructions on the deter-
gent packaging.
Detergent tablets do not fully
dissolve with short programmes
and detergent residues can stay
on the dishes.
We recommend that you use
detergent tablets with long pro-
grammes.
the appliance.
setting mode.
til the indicator of the programme
that you want to set comes on.
• The programme duration flashes
in the display.
• The phase indicators of the set
programme come on.
• Only the indicator of the phase in
operation stays on.
ENGLISH
35