IKRA THS 500 Pro Manuel D'utilisation page 32

Troubleshooting
Problem
Unit does not run
Blade cutter is running hot
Blade cutter will not move
Excessive vibrations/noise
Pole trimmer operates intermittently
Possible Cause
Power cord not connected
Lock off not fully operated
Blade cutter dull
Blade cutter has dent
Too much friction, due to lack of
lubricant
Machine defective
Machine defective
Internal wiring of machine damaged
On/Off switch defective
GB-15
Possible Solution
Check power supply connection
Check that lock off is fully forward
prior to moving trigger
Have blade sharpened
Have blade inspected/ overhauled
Apply lubricant spray
Contact Service Agent
Contact Service Agent
Contact Service Agent
Contact Service Agent