Dremel 4300 Consignes De Fonctionnement/Sécurité page 38

1600A00N3H.qxp_4300 7/8/16 10:34 AM Page 38
Installation instructions to Dremel Multi-
The tool with the guide attached can be taken
to a secure workpiece or can be stationary in
the Dremel Multi-Vise 2500-01 (Sold
Separately).
1. Set up Dremel Multi-Vise on secure
workbench. Place the tool holder into the
Dremel Multi-Vise according to Dremel
Multi-Vise instructions.
2. Place tool with accessory secure through
the tool holder F (Fig. E4).
Detailer's Grip Attachment Model A577
for the use of this accessory with your tool.
Failure to follow all instructions listed below
may result in serious personal injury.
rotating bit.
The attachment comes with its own nose piece
to tighten the handle to the tool.
Detailer's Grip Attachment
Installation Instructions
1. Remove the nose cap A from the end of the
tool and set nose cap aside. The original
nose cap must be reinstalled when this
attachment is not used (Fig. F1).
FIG. F1
A
38
Vise:
Read the tool manual
and these instructions
Prevent fingers from
making contact with
Do not tighten detailer's
grip over shaft lock button.
3. Hold the Sanding/Grinding Guide B firm
and thread onto front end of tool until tightly
secure (Fig. E4).
4. The guide can be adjusted from the 90
degree side to the 45 degree side by
loosening the wing nut D and sliding the
attachment B off the cylinder E (Fig. E5).
5. Turn the attachment B 180 degrees and
slide the attachment B onto the cylinder E
and tighten wing knob D at desired depth
(Fig. E5).
2. Place handle B over housing collar C with
the handle in the desired position and
securely tighten the handle B with the nose
piece D that's provided with handle (Fig.
F2).
Make sure detailer's grip is fully secured before
using tool.
Note: Attachment may not install flush onto
tool's housing.
Removing the Detailer's
Grip Attachment
1. Hold the handle B firmly and twist the tool
until the nose piece D is loose. Remove
nose piece D and handle B from housing
collar C and reinstall original nose cap A
(Fig. F2).
FIG. F2
C
D
B