FAR RAC 171 Mode D'emploi page 11

RAC 171
f5
18 mm
M
f6
N
f7
A
Revision - 04
14 mm
GB
TOPPING UP THE OIL-DYNAMIC CIRCUIT (fig. f8)
You need to top up the oil-dynamic circuit after a long period of
work, when you note a power loss. Put the riveting tool (DWELL
AND NOT FED) in a horizontal position and remove the plug (F),
by means of a 5 mm Allen wrench (equipped with the riveting
tool); during this operation, check the oil level in order to avoid
any overflowing. Then, slowly pour the oil VISCOSITY 32° into
the bellows container (O) which shall be screwed to its seat on
the plug (F). While keeping the riveting tool in a horizontal position
and starting air feeding, push the tensile strength button and make
the riveting tool carry out some cycles until air bubbles inside the
container (O) stop coming out. This condition indicates that the
topping up of the oil has fully been achieved. At this point, while
keeping the riveting tool in a horizontal position, unscrew the oil
container (O) and close it again.
Do not push the tensile strength button during this operation. Go
on by closing the oil tank plug (F).
WARNING: it is very important to follow the about mentioned
instructions and use gloves. If you need to empty fully the hydraulic
circuit, you must put the oil in a suitable container and contact a
Company that is authorized to discharge any waste.
WARNING!
Before disconnecting the compressed air hose,
make sure that it is not under pressure.
WARNING: Make sure that the oil filler cap (F) is
tightened at a torque corresponding to Min. 5 Nm
÷ Max. 8 Nm.
min. 5 Nm
max. 8 Nm
f8
Date 09-2008
F
O
11