Protect The Environment - Jaga Dynamic Clima Beam T 20 Instructions D'installation

– during installation and maintenance, always wear suitable personal safety equipment, such as
safety shoes, safety goggles, etc.
– the unit has sharp edges; always use gloves
– always switch off and unplug the power supply before installation or maintenance
– do not insert body parts or objects in the air inlet or outlet
– pay the utmost attention to the signs and symbols located on the appliance
HANDLING AND TRANSPORT
– movement of the unit must be performed with care, in order to avoid damage to the external struc-
ture and to the internal mechanical and electrical components
– also make sure that there are no obstacles or people along the route, in order to prevent the risk of
impact, crushing or tipping the lifting device
– the units can be moved or lifted by hand or by means of a suitable truck. If the unit weighs more
than 25 kg and is to be handled manually, this must be carried out by two persons: however, it is
recommended to use a truck.
– all the operations listed below must be carried out in accordance with current health and safety
regulations, with reference to the equipment used as well as the procedures followed. Before com-
mencing handling operations, ensure that the lifting device has the required capacity for the unit in
question
– if several units need to be moved at the same time, it is advisable to put the units in a container and
lift them by means of a crane or similar vehicle.
PACKAGING
– PROTECT THE ENVIRONMENT: remove the packaging materials and dispose them at the proper
collection points or recycling facilities in accordance with the local regulations
– keep the packaging out of the reach of children
INSTALLATION
– mount the device on a sturdy and stable surface
– before starting the unit, the room must be dry and dust free, this can cause serious damage to the
motor and heat exchanger.
– installing the unit is an explosive environment is prohibited
– avoid liquids entering the device
– devices that produce an open flame may not be installed at places that are within the airflow of the
device
– install this product in a location with a temperature between 5 °C and 70 °C
– install this product in a location with a relative humidity less than 90%
– Incorrect positioning or installation of the unit may amplify noise levels and vibrations generated
during operation
– an incorrect positioning or installation can amplify the noise levels and vibrations that occur during
operation
– the device must always be accessible for maintenance
CONNECTION
– Non-conforming electrical and hydraulic connections releases Jaga N.V. from liability concerning
damage to objects and persons.
– The clima beam system is a dry-cooling system and therefore the inlet water temperature must al-
ways be above the dew point temperature. if condensation occurs, the water flew in that area must
be stopped, even before looking for the cause of the condensation. It is important that the dehumi-
dification by the air-handling unit has been set correctly and that the control operates properly. In
order to avoid the formation of condensation, the customer must check the dew point, and prevent
the temperature from droppig below the dew point. Jaga can not be held liable for damage caused
by condensation.
USE
– this device is not intended to be used by people (including children) with reduced physical, sensory,
or mental capacities, or who lack experience or knowledge, unless a person responsible for their
safety supervises them or has explained how the device must be operated
EN
47