GreenWorks GPW 1802 Manuel Du Propriétaire page 14

ASSEMBLY
CONNECTING THE GARDEN HOSE
See Figure 7.
C A U T I O N
Always observe all local regulations when connecting hoses to the water main. Some areas have
restrictions against connecting directly to public drinking water supply to prevent the feedback of
chemicals into the drinking water supply. Direct connection through a receiver tank or back flow
preventer is usually permitted.
• Uncoil the garden hose.
NOTE: There must be a minimum of 10 feet of unrestricted garden hose between the water
intake and the garden hose faucet or shut off valve (such as a "Y" shut off connector).
• Run water through the hose (A) for 30 seconds to clean any debris from the hose.
• Inspect the screen in the water intake (B).
• If the screen is damaged, do not use the machine until the screen has been replaced.
• If the screen is dirty, clean it before connecting the garden hose to the machine.
• With the hose faucet turned completely off, attach the end of the garden hose to the water
intake. Tighten by hand only.
A
Fig.7
B
14