8.0 nailing tabs and strips
EN
8.1
nailing tab installation (located in manual baggie)
1. To install the appliance face flush with the finished surface, position the framework to accommodate the
thickness of the finished surface.
2. Remove the 4 screws (FIG. 1).
3. Install the 4 nailing brackets on both sides of the appliance, and secure to the 2x4 framing.
note:
The tabs will facilitate the installation of either a 1/2" (12.7mm) or 3/4" (19.1mm) finished surface thickness.
FIG. 1
Reverse Side
View
8.2
nailing strip installation
1. Remove the nailing strip from the back side of the carton sleeve.
2. Remove the 2 screws from the outer top edges of the nailing strip.
3. Place the nailing strip in place and secure with the 2 previously removed screws (FIG. 1).
FIG. 1
Back Side View
19
W415-1796 / B / 08.01.18