Firing Spool Disassembly/Assembly; Valve Spool Spacer Disassembly/Assembly; Valve Body Power Tube Disassembly/Assembly - Tippmann X7 Phenom Manuel D'utilisation

Regulator Piston Assembly
(Item 21 in the previous diagram on page 20.)
This assembly is factory preset, and it is not recommended for disassembly.
This assembly has parts with locktite applied, and should not be adjusted or disassembled.
The Regulator Vent Post (4) has been factory set to vent at pressures above 350 psi.
If this assembly requires replacement, please contact Tippmann Technical Support at 1-800-
533-4831 for fast, friendly service.

Firing Spool Disassembly/Assembly

(Item 9 in the previous diagram on page 20.)
If defective O-rings are found, replace with new parts. Use Tippmann
after installing O-rings onto the Firing Spool and before installing into the Valve.

Valve Spool Spacer Disassembly/Assembly

(Item 11 in the previous diagram on page 20.)
If defective O-rings are found, replace with new ones. Use Tippmann grease on new O-rings
after installing O-rings onto the Firing Spool and before installing into the Valve.

Valve Body Power Tube Disassembly/Assembly

Using a small flat screwdriver or a pick, you can remove the Spiral Retaining Ring (5) to allow
the Power Tube (6) to be removed. Reassemble in the reverse order.
23
grease on new O-rings
®
E
N
G
L
I
S
H