Air Supply Cylinder Warnings - Tippmann X7 Phenom Manuel D'utilisation

Air Supply Cylinder Warnings

The brass or nickel plated cylinder valve (figure 9, #1) is intended to
be permanently attached to the air or CO
An air or CO
2
injury or death if the cylinder (2) unscrews from a cylinder valve (1).
Refer to Figure 9. There have been reported incidents caused by players unknowingly
unscrewing the cylinder (2) from the cylinder valve (1). This occurs when the player thinks
the entire valve-cylinder assembly is being unscrewed from the air supply adaptor of the
paintball marker, when in fact they are unscrewing the cylinder
from the cylinder valve.
To avoid this danger, it is recommended (if your cylinder is not
already marked) that you use paint or nail polish to place a
mark (3) on the cylinder valve, and place another mark (4) on
the cylinder, in line with the #3 mark as shown.
Whenever you turn the cylinder during removal, watch the
marks on the cylinder and the cylinder valve to be sure
that they rotate together. If at any time these marks start to
separate as shown in Figure 10, the cylinder is starting to
unscrew from the cylinder valve and you must STOP and
take the entire unit to a "C5" certified airsmith for safe removal
and/or repair.
NOTE: The cylinder valve should unscrew from the paintball
marker in about 3 or 4 full turns. If you finish the 4
and the cylinder valve is not unscrewed from the paintball
marker, STOP! Take the entire unit to a "C5" certified airsmith
for safe removal and/or repair.
Locate a "C5" Certified Airsmith at www.paintball-pti.com/
search.asp.
Whether you have a new or used refillable air or CO
you are at risk if any of the following has occurred:
• The valve unit was replaced or altered after purchase.
• An anti-siphon device was installed.
• The valve unit was removed from the cylinder for any reason.
• Any modification was done to the refillable air or CO
If any of these conditions has occurred, take your air or CO
Airsmith for inspection or contact the cylinder manufacturer.
WARNING
cylinder can fly off with enough force to cause serious
cylinder (2).
2
1
Figure 9: Properly marked
3
full turn
th
cylinder,
Figure 10: Misaligned Valve
2
cylinder.
2
cylinder to a "C5" Certified
2
13
2
3
4
Valve and Cylinder
4
and Cylinder
E
N
G
L
I
S
H