Phenom Disassembly And Assembly - Tippmann X7 Phenom Manuel D'utilisation

Phenom Disassembly and Assembly

Always wear eye protection when performing any marker disassembly or re-assembly.
Refer to the Assembly Diagram on page 18 for these instructions (item numbers are in
parentheses). Disassembly instructions are listed here. To re-assemble, just do the steps in
the reverse order.
1. To remove the
reinstall it, just turn it clockwise to thread it into the Upper Receiver.
2. To remove the
pins (12 and 13), from the assembly. Notice that #12 is longer than #13; keep them
separated. The Front Grip/Shroud Assembly can now be removed. To remove the
(19), remove the
Front Sight
Front Sight towards the muzzle end of the barrel until
it comes off.
3. To remove the
the magazine button (see arrow in Figure 11), then pull
the magazine down to remove. Be sure to keep the
opposite side of the receiver clear while pressing the
button to allow the magazine to release. The Magazine
is designed to hinge open to allow for storage of tools
and grease.
4. To remove the
instructions), pull both push pins (12), from the Lower Receiver assembly. Pull the
Lower Receiver straight down to get it apart from the Upper Receiver (1) assembly.
5. Remove remaining parts from the
breakdown)
a. Remove the remaining
b. Pull the End Cap (11) from the rear of the Upper Receiver.
c. Pull the
Pressure Gauge Plug
d. Slide the Cyclone Feed System
Hose Fitting from the Valve assembly.
e. The
Valve
and the
Compression Spring
Receiver. Inspect, clean, and lubricate the specified parts with Tippmann grease
every 8-10,000 shots and prior to re-assembly.
6. To remove the
clockwise and lifting from the Cyclone Feed System. Remove the
(4) should have been disconnected in the previous step. Set the Cyclone Feed System
aside; see pages 28-29 for the parts diagram and parts list for the Cyclone Feed
System.
7. To remove the
Receiver rail.
(17), simply unscrew the Barrel from the Upper Receiver, and to
Barrel
Front Grip/Shroud Assembly
Bolt
(18) from the receiver, press
Magazine
(10, also see pages 26-27 for parts and disassembly
Lower Receiver
Upper Receiver
Push Pin
assembly (item 8, see page 20 for parts),
Cyclone Feed System
(21), remove the
Rear Sight
(16), pull each of the two push
(20) and slide the
Figure 11: Magazine Release
(1, see pages 24-25 for parts
(13) from the
End Cap
(9) from the Upper Receiver.
(3) back to the key hole and pull the
Hose Fitting
(6) all slide out from the open end of the Upper
(14), first remove the
(20) and slide off from the Upper
Bolt
19
Button
(11).
assembly (7),
Front Bolt
(22) by turning
Hopper
(15). The
Bolt
E
N
G
L
I
S
H
Hose