Programming Navigation - Tippmann X7 Phenom Manuel D'utilisation

- (Factory Default Value = 13 bps) The Rate-of-Fire menu item may be used to
Rate-of-Fire
change the Safe Full-auto Firing mode. This is the only Firing Mode which is affected by this
menu item. All other Firing modes cannot have their rate of fire adjusted. This menu item can
only be changed with values of 8-15 bps.
- (Factory Default Value = 2 Safe Full-auto) The Firing Mode menu item is
Firing Mode
used to change the default Firing Mode. The value and corresponding Firing Mode are listed
below.
1. Safe Three-shot Burst
2. Safe Full-auto (factory default)
3. Auto-Response
4. Turbo Mode
5. Semi-automatic
The Firing Mode menu item can only be changed to a value of 1 through 5.

Programming Navigation

Entering Programming
15). Never attempt to do Advanced Programming on a pressurized marker!
Put the Selector Switch in Safe mode. Press and hold the Programming Button and move
the Selector Switch to the FA mode. After 2 seconds, the LED turns solid red. Release the
Programming Button. You are now in the main programming menu. Cycle through the menu
items using trigger pulls.
Cycling through the menu
trigger. Each time the trigger is pulled and released, a different color code is displayed by the
LED as listed in Advanced Programming on page 10.
Enter a menu option
pull and hold the trigger for two seconds.
- Upon entering a menu item, the LED begins flashing red. The flashes
Current Value
represent the current menu value. The current value is flashed twice with a short pause
between the value flashes. If a new value is not entered before the end of the second value
flash display, the electronics automatically return to the main menu.
Enter a new value
can be entered by pulling and releasing the trigger. Each pull and release of the trigger
counts as 1 when entering the new value. For example, to enter a number 5, pull and release
the trigger five times.
Successfully updated menu confirmation
item, the LED flashes red/orange/green twice to signify an acceptable value has been
entered. The electronics then returns to the main menu. If an unacceptable value is entered,
the LED quickly flashes red, and returns to the main menu. The value of the menu item
remains unchanged if this happens.
- After a menu item has been changed, you must power-off the electronics
Power Off
before the change takes effect. Move the Selector Switch to the Safe mode (S) or
Mechanical mode (F), and the electronics power down. Move the Selector Switch back to the
FA position to power up the electronics and use the new settings.
Optional Factory Settings Reset
Default Settings. Move the Selector Switch to the FA position. Press and hold the
programming button for 10 seconds. Release the Programming Button, the LED flashes red/
orange/green twice. The electronics power down for 10 seconds and then power back up. All
settings are reset to factory defaults at this point.
- Unload the marker (page 12) and remove the air supply (page
- To cycle through the menu items, pull and release the
- Once the LED displays the color code of the desired menu item,
- Any time while the LED is flashing with its current value, a new value
- You can reset programming back to the Factory
- Once you enter a new value for a menu
11
E
N
G
L
I
S
H