Cleaning And Maintenance - Tippmann X7 Phenom Manuel D'utilisation

E

Cleaning and Maintenance

N
G
• To reduce the chance of an accidental discharge, follow the Unloading Your Marker
L
(on page 12) and Air Supply Cylinder Removal (on page 15).
I
• Eye protection must be worn.
S
H
• Do not disassemble a marker while it is pressurized with air.
• Do not pressurize a partially assembled marker.
• Follow warnings listed on the air supply cylinder for handling and storage.
• Familiarize yourself with instructions listed on air supply cylinder.
• Contact the air supply cylinder manufacturer with any questions.
• Do not use any petroleum based cleaning solvents.
• Do not use any cleaning solvents that come in aerosol cans.
NOTE: Petroleum based products and aerosol products can damage your markers'
O-rings.
To clean your paintball marker exterior, use a damp towel to wipe off paint, oil, and debris.
To clean inside the barrel:
1. Remove the barrel (item 17 on page 18) by unscrewing it from the Upper Receiver.
2. Insert the tab end of the cable squeegee into barrel.
3. Pull the squeegee through the barrel to remove debris and paint.
To maintain your marker in good working condition, inspect, clean, and replace any
damaged parts.
Every 8,000 to 10,000 shots, lubricate specific areas (marked with a G) as instructed in the
Phenom Disassembly/Assembly section, shown on pages 18 and 20. Other than to clean
and grease these specified areas, it is unnecessary to disassemble your Phenom marker for
general maintenance.
The best valve O-rings are made of urethane. Urethane O-rings are not affected by high air
supply pressures. These may be purchased from Tippmann
Use Tippmann grease to lightly lubricate the O-rings, springs, and other areas indicated in
Phenom Disassembly/Assembly instructions.
Use Tippmann grease to maintain your marker in good working condition. Inspect and
lubricate the air supply valve O-ring with a few drops of grease when attaching the air supply
cylinder.
or your local paintball dealer.
®
16