Barrel Blocking Device Installation Instructions - Tippmann X7 Phenom Manuel D'utilisation

E
N
G
L
This is not a toy. Misuse may cause serious injury or
I
death. Eye, face, and ear protection designed for paintball
S
must be worn by the user and any person within range.
H
We recommend you be at least 18 years old to purchase.
Persons under 18 must have adult supervision when
using this product. Read the Owner's Manual before using
this product.
Always keep the barrel blocking device installed except
when your marker is in use. Always make sure that the
Selector Switch is in the Safe mode (see instructions on
page 6) and the barrel blocking device is properly installed
on your marker according to the instructions to prevent
damage to property, serious injury, or death.

Barrel Blocking Device Installation Instructions

1. Insert the barrel blocking device onto the
Barrel, and loop the cord over the top of the
receiver and position at the back of the grip
as shown.
2. Adjust the cord length retainer up to the back
of the grip by pulling the cord through it until
the retainer is snug against the back of the
grip. Keeping the cord as tight as possible,
leave just enough cord elasticity to pull the
cord/retainer up over the top of the marker to remove
the barrel blocking device for firing.
3. After the cord length is properly adjusted, lock the
cord length by tying a knot in the cord against the
back of the retainer as shown.
4. Before and after playing, inspect the barrel blocking device.
Replace the barrel blocking device if the device or cord is
damaged, or there is a loss of cord elasticity.
5. Clean the barrel blocking device with plain, warm water and store out of sunlight in a dry
area when not in use.
WARNING
WARNING
Barrel Blocking Device
4
Cord
Length
Retainer