Option Selections - KitchenAid KUDS24SE Guide D'utilisation Et D'entretien

Operating Your dishwasher
Cancel
anytime
Customize
your cycles
20
Canceling a cycle
You can cancel a cycle anytime during
the cycle.
1. Press the Cancel pad once, then wait.
The Cancel light will glow. There
is a 5-second pause between
CANCEL
the time Cancel is pressed and
draining begins.

Option selections

Press a pad to select an option. If you
change your mind, press the pad again to
turn the option off. To select a different
option, press another pad.
High Temp. Wash
Select this option, and water will heat during
the main wash for better cleaning
HIGH
of heavily soiled dishes. Water
TEMP.
heating is automatic in the wash
WASH
portions and final rinse of the
Soak & Scrub cycle, and in the final rinse of
the Normal, Short Wash, and Light China
cycles.
Energy Saver Dry
Use this option to air dry dishes without heat.
For best results, keep the rinse
ENERGY
agent dispenser filled. Under
SAVER
certain conditions (hard water,
DRY
empty rinse agent dispenser,
plastic items in the load, etc.) you might find
some water left on plastics, dishes, and
silverware.
2. Let the dishwasher drain completely.
SANI RINSE* Option
The SANI RINSE option raises the water
temperature in the final rinse to
approximately 155°F (68°C). SANI
SANI
RINSE is an option with all cycles
RINSE
except Rinse Only. Depending on
the incoming temperature of your water, cycle
times might be longer when you select SANI
RINSE.
NOTE: The SANI RINSE cycle raises the
temperature of the final rinse to approximately
155°F (68°C), and maintains that temperature
for at least 16 minutes. This high temperature
rinse sanitizes your dishes and glassware in
accordance with the NFS International re-
quirements (#95/480/2480).
Delay Hours
The Delay Hours light glows when the dish-
washer has been set for a delayed
start. The delay light will turn off
DELAY
when the cycle starts. See "Setting
HOURS
a delay start" later in this section.