Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
...................... Class I Construction
(grounded)
.../min ..............per minute
BPM ....................beats per minute
IPM .....................impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM ....................strokes per minute
A .........................amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
ASSEMBLY
•
Slide the handle into the base of the vacuum as shown
in Figure B.
Figure B
•
Fasten the two parts together with the supplied screw
as shown in Figure C. Ensure vacuum is assembled
securely.
Figure C
•
Slide the nozzle
of the hand vac into the bottom of
3
the chassis
and push the vac fully into the chassis
15
until you hear a snap as shown in Figure D.
•
To remove, depress the hand vac release button
and pull the hand vac out.
...................... Class II
Construction
(double insulated)
n o .......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
14
Figure D
Charging the battery
WARNING: For use only with the supplied charger.
•
Before first use, the battery must be charged for at least
4 hours.
•
Plug the jack plug
17
socket of the tool as shown in Figure E. Plug the charger
into any standard 120 Volt 60 Hz electrical outlet.
WARNING: Before charging, be sure to empty all
contents and dry thoroughly if needed to avoid
damage to your appliance.
nOTE: While charging, the charger may become warm. This
is normal and does not indicate a problem. The appliance
can be left connected to the charger indefinitely.
WARNING: Do not charge the battery at ambient
temperatures below 50 °F or above 104 °F.
Figure E
Switching on and off - Figure F
•
To switch the appliance on, depress the on/off button
. The battery indicator LED will illuminate and vacuum
1
will begin in the low-speed mode.
•
Depress the button a second time to engage the
POWERBOOST mode. The green LED will also illuminate,
indicating the vacuum is in the higher-speed mode.
English
of the charger into the charging
3
Publicité
Table des Matières
