Attach The Blood Pressure Cuff; Start The Measurement - Welch Allyn Rpm-Bp100 Mode D'emploi

14 Use the monitor

Attach the blood pressure cuff

The preferred blood pressure measurement site is the upper arm. Keep your arm relaxed
and motion-free during measurement(s).
Complete these steps to attach the blood pressure cuff to your arm.
1. Bare your arm to attach the cuff.
2. Sit comfortably with your legs uncrossed, feet flat on the floor, and back and arm
supported.
The center of the cuff should be at the same level as the right atrium of your heart.
3. Attach the cuff to your upper arm with the air hose off-center toward the inner side
of your arm in line with your little finger.
The cuff should be snug but not too tight. You should be able to insert one finger
between the cuff and your arm.
4. Sit comfortably with your arm resting on a flat surface.
5. Rest 5 minutes before beginning the measurement.
6. Wait at least 3 minutes between measurements. This allows your blood circulation
to recover.
For a meaningful comparison, try to take measurements under consistent conditions. For
example, take daily measurements at approximately the same time, on the same upper
arm, or as directed by your physician.

Start the measurement

The preferred blood pressure measurement site is the upper arm. Keep the patient's arm
relaxed and motion-free during measurement(s).
When the monitor is off, press the Power/Standby button to power up the monitor
and begin the measurement.
It will finish the entire measurement. During inflation, the heart icon in the upper-left
corner blinks in keeping with your pulse rate.
After successful transfer, the device powers off the Bluetooth radio and the icon (and
rectangle) are removed.
If you press and release the Power/Standby button, the device powers down.
If there is no operation, after a 10 seconds of inactivity, the device powers down.
Additionally, during inflation the progress meter to the right of the digits builds vertically
as the pressure increases according to the table below.
Segments
1
2
3
4
Welch Allyn Remote Monitoring Blood Pressure Device RPM-BP100
Pressure
>=0
>=40
>=80
>=120
Mode d'emploi
Symbole Description
Hors plage.
Informations de présentation 11
Explication
Soit SYS < 60 mmHg ou DIA < 40 mmHg. Le symbole
peut apparaître dans la zone SYS ou DIA de l'écran.
Priorité de l'alarme = Bas