Roco BR 03 0058-2 Série Manuel page 26

Table des Matières

Les langues disponibles

Please note! To achieve proper moun-

ting of the enclosed etched labels will

you please follow these instructions:

As delivered the etched label surface is

completely covered with paint. To make

the metal numbers and letters visible the

paint must be removed from the actual letter and numeral surfaces: this is done as follows:

1. Before removing the labels from the etched frame place them with their backs on a firm and com-

pletely level surface.

2. Remove the paint from the surface of the characters carefully either with the ROCO rubber (art. no.

10002) a sharp knife having a straight edge or similar

object (e.g. single-edge razor blade). Take care that while doing this the paint surface between the

characters is not damaged.

3. If the result is not satisfactory it is recommended that the remaining paint is removed with a suitab-

le paint remover. Thoroughly dry the labels and then

reapply fresh paint. Repeat the removal of the paint from the surface of the characters after the new

paint is completely dry.

4. Carefully extract the different labels from their etching frames and remove any remaining burrs.

5. Attach the etched labels with very small amounts of adhesive on top of the printed signs on the

vehicle.

Working with etched Labels

Deutsche Reichsbahn

kleben

cement

coller

Deutsche Reichsbahn

kleben

cement

coller

Cement

Table des Matières

Chapitres

Table des Matières

72205 72206 78206