Backrest Adjusting / Seat Inclination - Vermeiren EZ1 Mode D'emploi

2
1

2.10 Backrest adjusting / Seat inclination

L L L L
WARNING:
Risk of tipping over – Be aware that the stability decrease when the
backrest is adjusted backwards.
L L L L
WARNING:
Risk of injury – Apply the parking brakes before adjusting the
backrest and seat inclination.
The seat and the backrest can only be adjusted simultaneously or independently from one
another in their angle by an attendant. Be sure that the patient sits in the chair when the
attendant shall perform the back adjusting, seat inclination and that the wheelchair does not
tip over.
Seat inclination:
Backrest adjusting:
1. Pull lever on the right side (see label) towards the handgrip
the backrest.
2. Pull/Push the backrest in the desired position (-5° to + 50° ), the gas pressure spring
shall be pressed in/out.
3. Loosen the lever
If your wheelchair features drum brakes, the levers
levers have been mounted for adjusting angle of backrest and seat inclination.
These levers can be triggered with the thumb.
The pushing handgrips can be adjusted in
height according to the size of the attendant
person.
The handgrips can be adjusted by following
instructions.
1. Loosen the star buttons
2. Place the pushing handgrips in the desired
height for the attendant person.
1
3. Retighten the star buttons
4. Check that the handgrips are firmly
fixated.
1. Pull lever
towards the handgrip
inclination.
2. Pull/Push the seat in the desired position (-5° to
+ 15° ), the gas pressure spring shall be pressed
in/out.
3. Loosen the lever
spring.
Label
, to block the gas pressure spring.
Page 10
on each side.
on each side.
on the left side (see label)
to adjust the seat
Label
, to block the gas pressure
to adjust the angle of
are used as brakes; additional
EZ1
2012-12