Backrest Adjusting / Seat Inclination; Transport In The Car - Vermeiren Inovys II-F Mode D'emploi

2.17 Backrest adjusting / Seat inclination

L
WARNING:
Risk of tipping over – Be aware that the stability decrease when the
backrest is adjusted backwards.
L
WARNING:
Risk of injury – Apply the parking brakes before adjusting the
backrest and seat inclination.
The seat and the backrest can only be adjusted simultaneously or independently from one
another in their angle by an attendant. Be sure that the patient sits in the chair when the
attendant shall perform the back adjusting, seat inclination and that the wheelchair does not
tip over.
Seat inclination:
Backrest adjusting:
1. Pull lever  on the right side (see label) towards the handgrip  to adjust the angle of
the backrest.
2. Pull/Push the backrest in the desired position (0° to + 54°), the gas pressure spring shall
be pressed in/out.
3. Loosen the lever , to block the gas pressure spring.
If your wheelchair features drum brakes, the levers  are used as brakes; additional
levers  have been mounted for adjusting angle of backrest and seat inclination.
These levers  can be triggered with the thumb.

2.18 Transport in the car

L
DANGER:
Risk of injury – The wheelchair is not suited for use as a seat in a
motor vehicle.
L
WARNING:
Risk of injury – See that the wheelchair is attached properly. So you
can avoid injury from the passengers during collision or sudden braking.
L
WARNING:
Risk of injury – Use for attaching the wheelchair and passenger
NEVER the same seatbelt.
Never use your wheelchair as a seat in an automobile or other vehicle. The wheelchair shall
be marked with following symbol.
1. Pull lever  on the left side (see label)
towards the handgrip  to adjust the seat
inclination.
Label
2. Pull/Push the seat in the desired position (0° to
+ 21°), the gas pressure spring shall be pressed
in/out.
3. Loosen the lever , to block the gas pressure
spring.
Label
Page 14
Inovys II-F
2016-05