Starting And Stopping; Starting Instructions - Remington RM1035P Manuel Du Propriétaire

WARNING:
Never operate the unit without the guide bar
and saw chain properly installed. Make sure the guide bar
cover is securely assembled. Make sure the saw chain is
properly tensioned. Refer to Adjusting the Chain Tension
instructions in the Maintenance section.
WARNING:
The saw chain will spin after the unit starts.
Keep hands and feet clear of the saw chain and do not
allow the saw chain to contact any object(s).
BEFORE STARTING THE UNIT
1. Fill the chain oil reservoir with bar and chain oil. Refer to Adding
Bar and Chain Oil in the Maintenance section.
2. Connect the power cord to an appropriate extension cord.
Connect the extension cord to an appropriate power outlet.
Refer to Connecting and Disconnecting the Power Source.

STARTING INSTRUCTIONS

NOTE: To help prevent the motor from starting accidentally, this unit
has a trigger lockout. The trigger lockout and trigger must both
be engaged to start the unit.
1. Press and hold the trigger lockout (Fig. 6).
2. Continue to hold the trigger lockout. Squeeze and hold the
trigger to start the unit (Fig. 6).
3. Release the trigger lockout, but continue to squeeze the trigger.
STOPPING INSTRUCTIONS
1. Release the trigger and wait for all moving parts to come to a
complete stop (Fig. 6).
NOTE: Upon release of the trigger, the trigger lockout will reset to
the locked position.

STARTING AND STOPPING

15
Trigger Lockout
Trigger
Fig. 6