IKEA GRUNDLÄGGA Mode D'emploi page 17

EN
Triple radiant surface elements
Symbols around the knob are used to indicate which
element of the triple radiant element will heat.
The symbol indicates that only the inner element
will heat.
The symbol indicates that the inner and middle
elements will heat.
The symbol indicates that the inner, middle and
outer elements will heat.You may switch the element
setting at any time during cooking.
To Operate the Triple Surface Element
1. Place correctly sized cookware on the triple surface
element.
2. Push in and turn the control knob to the inner ele-
ment symbol for smaller cookware or to the inner and
middle element symbol for average cookware or to
the inner, middle, and outer element symbol for large
cookware (Figure 8). Turn the knob to adjust the set-
ting if needed.
3. When cooking has completed, turn the surface control
knob to OFF before removing the cookware.
Start most cooking operations on a higher setting
and then turn to a lower setting to finish cooking.
A glowing red surface heating area extending be-
yond the bottom edge of the cookware indicates the
cookware is too small for the surface heating area.
You may switch to the single, dual, or triple element
setting at any time during cooking.
CAUTION
Radiant surface elements may appear to have
cooled after they have been turned off. The ele-
ment may still be hot and burns may occur if the
element is touched before it has cooled sufficiently.
Do not place flammable items such as plastic salt
and pepper shakers, spoon holders, or plastic
wrappings on top of the range when it is in use.
These items could melt or ignite. Potholders, tow-
els, or wooden spoons could catch fire if placed too
close to the surface elements.
SETTING SURFACE CONTROLS
Figure 8: Single, dual, and triple elements
IMPORTANT
Do not allow aluminum foil or ANY material that
can melt to make contact with the ceramic glass
cooktop. If these items melt on the cooktop, they
will damage the ceramic cooktop.
17